Questions & Answers for: Jeep Wrangler hydraulics

1990 yj manual trans will not go in any gear driving down the road and pushed in the clutch pulled it out of gear and then would not go back in any gear. clutch is working properly trans is turning ...

changeed the flywheel and hydraulic throtle baring / clutch slave now wont go in to gear grinds bad any answers You have air in the hydraulic system, sometimes there is a funky bleeding routine. I ...

hydraulic system 1994 jeep wrangler ??? My clutch was very sloppy and I had to had my car towed. I have been told it is the hydraulic system and it needs to be replaced. Any body out there --- Have ...

go to the floor. If this is ok then a portion of the clutch MIGHT have went out. Let me know if the hydraulics are ok

Hydraulic or ? ? ? 93 wrangler clutch - I was losing pedal yesterday and this morning hardly no pedal while not being able to shift into gears at all. No noise nor leaks from anywhere. Do I have a ...

!991 Jeep Wrangler clutch pedal loses pressure. I have to pump it to get enough pressure to shift. I keep it full of brake fluid. I can see no leaks. Thanks for any help. leaky slave or master ...

i have a 1995 jeep wrangler reo grande.does it have a hydraulic clutch and if it does where do i check the fluid Yes...it has a hydraulic clutch. The clutch master cylinder should be next to the brake

1989 jeep wrangler cluch pedle goes to floor These jeeps have an hydraulic system with a master cylinder up top and a hydraulic line leading down to a slave cylinder. You likely have a leak somewhere ...

what fluid goes in the hydraulic release bearing on a 1990 jeep If you mean the clutch throw out bearing??? No fluid goes into it, as it is sealed with grease packing inside. You may have a hydraulic ...

where do you bleed the clutch at on a 1997 jeep wrangler what is the location of it This all depends if this is a hydraulic clutch or if its cable operated, you can only bleed hydraulic clutches, to ...