Questions & Answers for: hunter fan switch 3 speed

...Hunter fan. The pull chain broke inside the switch. Replaced with new Hampton Bay switch, but now, only low speed works. Suggestions? Thanks The cause to the problem was replacing a HUNTER fan switch ...

...Hunter fan models use the same switch and capacitors. If you need to replace the switch, the ones you get from your local hardware store will work just fine, but you can also order one from

switch. Fan now only runs on two speeds, need wiring diagram please I ran into this when replacing the 3 spd switch. The replacement switch has a pair of connections at each position; you would assume

hunter fan remote receiver which is housed in the based of the fan in ceiling. I realize that this is an old post. However, the best solution is to replace the receiver with 3 or 4 speed wire harness,

Hunter ceiling fan. I replaced it with a Westinghouse 3-speed fan switch # 77021 which I purchased at Home Depot. I was extremely careful to color label each wire (4 wires) the old control and the new

...Hunter Original fan's switch to be frozen, so I went in search of a replacement. I bought a 3-speed switch with similar wiring (red, blue, and black wires). I wired it up and turned it on. The speeds ...

...Hunter fan that came with the house. A-Unused B-Went to 1 (Blue Wire) C-Went to 2 (Red Wire) D-Went to L (Black Wire) I originally put B (the Blue Wire) into spot 3, leaving 1 unused. But that made ...

...Fan Switch - Hunter Zing Ear on Hunter 4 speed fan switch has failed. Switch number ZE-268s5. Hunter is no help. They show just the entire switches/capacitor/candelabra/switch housing assembly. If I ...

hunter cieling fan replacement zing ear switch ze-268s5 where can I locate this replacement part I never could find the 5 wire 4 speed replacement. I did however find a solution. 4-speed (five-wire) ...

...hunter fan with a three speed switch and no light kit. The wire colors are yellow, pink, grey, black. The pull switch has 4 ports - L, 1, 2, & 3. which color wire goes to which port? Thanks. ...