Questions & Answers for: Chevrolet hub meter

...one of the abs sensors that is either disconnected at the wheel hub or use an ohm meter on the connections to test the resistance. If you find one with OL, that is a short and look for a broken

Ad

Question about 1999 Silverado 1500

1 Answer

...Meter (DVM) across the terminals of each WSS connector. Rotate the wheel clockwise approximately one revolution per second. The minimum reading should be at least 350 ACmV's. If the reading is less ...

Ad

...ohm meter and check the resistance on both front hubs. Check from hub to ground on both wires should have unlimited and the check across both wires and I think the spec is around the 1000 to 1300 ...

Question about 2002 Monte Carlo

1 Answer

...hub or bearing. these are for your anti lock brake system. the wire could be broke on inside of insulation too so check carefully. can check wheel sencers by unplugint each one and checking with volt ...

...hub stay's locked in the on position. Good luck and keep me posted, You can pick up the vacuum switch at Auto Zone or Parts Source for around $25.00 and they will have the step by step instructions ...

...on dash stays on!what does the sensor,follow is it a gear in the backside of the rotor?these hubs are all one piece!this is an s10 2wheel drive. Yes,the sensor picks up and counts the teeth on ...

Question about 2004 Impala

2 Answers

...meter don't work Speed sensor is located in the wheel hub,drivers side. Remove that wheel,and make sure that the sensor line isnt wore thru. Its the ONLY componant screwed into the hub. really ...

hub. no matter way we use a voltmeter to solve this, riddle in 5min work. i always start in the middle (training) to make 1/2 the possible go byebye in 1 simple test. ask. if the relay dont pull in at

...Meter (DVM) across the terminals of each wheel speed sensor connector. 4. Rotate the wheel clockwise approximately one revolution per second. The minimum reading should be at least 350 ACmV's. If the ...

Question about 2000 Silverado

3 Answers

...meter. The speed sensors should have a connector along the side of each side frame rail. The sensor wire will be clipped to the upper control arm. Follow the harness forward along the frame rail and ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...