...pencil erasure crumbs. If the crumbs are present, your belt is disintegrating and needs to be replaced. The parts can be purchased at: ...
Printhead Path Hi, I am getting an error - check printhead path error type 2 Something (not sure what) is obstructing the movement of the carriage assembly. Turn off the power and remove the cleaners.
Question about DesignJet 1050c plus InkJet Printer
...HP Designjet 1050c Plus Changed printhead cleaners for Cyan, Magenta, Yellow and Black Switched plotter on and off and still the message 'Clear printhead path Type (1)' comes up The carriage for the ...
...printhead path error message We keep getting a check printhead path error message but don't understand why? Printer stops printing in the middle of a job and gives error message. hi the problem is ...
Question about DesignJet 1050c plus InkJet Printer
...Printer off,check printhead type path (2).The printer carriage head stops at the middle and displays the error. Machine name is Hp 1055cm plus plotter. it seems like there is no oil on the slide ...
Question about DesignJet 1050c InkJet Printer
HP Designjet 1050c begins to plot, then stops plotting with the error message "Turn of printer, check printhead path". What is the problem? you need to lubricate the slide bar with some thin oil ( ...
printhead path type 2", any suggestions. I have cleaned along the track but problem persists on power up. Head alignment begins and after a short while the error message is displayed there is an issue
...repair kit can be purcahased at: http://www.lpscomputer.com/c-654-designjet-1050c-1055cm.aspx The problem turned out to be a faulty drive motor, after replacing the motor plotterr has run Ok
HP 1050C Designjet I am getting the error 'Check printhead path Type 2. Then it says to switch off. Hello. The "Check Print Head Path" error is usually a worn out carriage belt on printers more than 5
Question about DesignJet 1050c plus InkJet Printer
hp designjet 1050c check printhead path (1) but the carriage barely moves? The problem started with a shreded belt. That was replaced. Then the check printhead path error showed up. The rods have been
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions