Questions & Answers for: how to tighten nut on rear wiper arm 2011 equinox

...wiper arm moves away from window, leaving it unable to wipe? its possible the nut that tightens the wiper arm has come loose. just center the wiper arm in proper position and try to tighten the

...tighten nut to 53 inch lbs. (6 Nm). Install shaft nut cover. Check wiper operation. Good luck (remember rated this post). The wiper motor is located under the black cowl in the front. remove the cowl ...

...rear wiper arm shaft seems to be broken, the motor seems to be fine. how do i take the assembly apart to check what is broken or replace the wiper arm? There is a plastic cover that pops off at the ...

...or u might need to pull the cover off at the bottom of the wiper and tighten the nut. it's stripped! remove the plastic cover at the wiper arm pivot align the wiper to position then tight down the ...

...tighten the wiper arm nut properly. Push the arm cap cover down. Secure the clip holding the cover to the wiper arm. Rear To Remove: Lift and hold the wiper arm away from the rear window. Lift the ...

...nut. Tighten to: 17 ft-lb (23 Nm) Nut cover Rear To Remove: Put the wiper arm in the park position. Remove or disconnect the following: The washer hose from the connector The cap from the wiper arm ...

...rear wiper to make sure it did not blow. Also, if you had the wiper replaced resently, then the nut on top of the wiper blade may not have been tightened down. It has tightened down what do I do now ...

windshield wipers dont work right one at all left one only half way then stops any ideas thanks tighten the hold down nuts on the wiper arms

tighten it. The arm is loose that's against car , it's not cleaning my rear widow at all. If you can move the wiper arm by hand, the nut attaching the wiper arm to the pivot is loose. There is usually

...arm. Carefully pull off wiper arm. Replace with new wiper assembly. Remember where wiper arm was and reposition it. Put nut on and tighten. Do not over tighten. put plastic cover on and your