Questions & Answers for: Power how to check ignition coil

coil at any time when turning motor over. Your bike is something of a classic and you could find more specialised information on an appropriate bike forum. Presumably it has an ignition module of some

...ignition checked wiring moved battery around, tried bike started fine firing on both, checked battery it was really warm had an issue a few years back where battery went out on run, bike lost power ...

...replaced a dynatek 2000i electronic ignition module, and now there is no power going to the coil or module. It is hooked up exactly the same, and not it is not getting power Check the ignition

order of power to the primary side of coil on 1998 heritage softtail classic The coil primary is provided 6v directly from the electronic ignition control. (Not sure what you mean by "order of power."

Got a 95 ninja 250.ignition is gone. Bypassed with toggle. Bike turns over strong has power to both coils but no spark at all the ground wire is still connected to the coils,wire a switch to that spot

...it start? no power could not start even kick no horn no signal light positive exest to the computer box Have you checked the battery? The fuses? The alternator? The power regulator? the ignition

right we have change the brain and it still has no power to the coil pack wat can be the problem immobilizer , cam/crank position sensors or ignition control module

My pulsar 150 not starting. There is no power coming from both lhs and rhs ignition coils. Is it the problem of cdi unit or starter relay. If so how can i rectify Get a shop manual for you bike, read ...

Check the ignition coil. If the coil is tired it will break down, causing rough running and loss of rpm and fuel economy. It's possible that, without consistent spark maintaining sufficient rpm's, the

...check the resistance. Maybe a coil wire is not seated or the coil and/or coil wire needs service or repair from being handled. Maybe it is a coincidence and there is another problem. If the ignition ...