hotpoint super silent ultima machine. During the spin cycle its so noisy and loud you have to leave the room, the feels that it is slightly loose as when you move it with your hand it makes a knocking
Question about Ultima WF860 Front Load Washer
...Hotpoint WF860 My machine leaks on every wash at the rinse cycle, I have checked the inner door seal and it has holes in it where something has burnt the rubber. How do I replace the seal when a new ...
hotpoint wf541p bearing hi....need to find a new bearing/kit for my hotpoint wf541p.....any clues???....cheers....mal ebay sell all kinds of bearing kits. about £10 usually.
noise when spinning Remove drive belt and spin drum by hand, if it is noisy, or feels rough, then the main bearings have failed, if no noise, then check for noisy motor bearings. Please rate my ...
Question about Ultima WF860 Front Load Washer
i have been told that i will need a replacement drum as my bearings have gone and the drum cant be split.is this true as a new drum is 200 quid. Not true, bearings can be bought and replaced.
Hotpoint Ultima WF860. The whole cycle will complete without the drum turning. You can hear an electrical hum during the periods when the drum should be turning. Previous to this fault occuring the ...
very noisy spin wf860 hi if you turn the drum by hand can you feel a slite rumble if you can it will be your drum bearings common problem on a machine that has had alot of use
...hotpoint wt960 belt is intact was getting very noisy before it stopped. now cannot move it with your hands looks like your bearings have gone if you can not move with hands looks like you need a new ...
Question about Ultima WF860 Front Load Washer
wf860 is very stiff and difficult to turn I suspect the bearings have gone what is the average cost of replcing bearings by engineer, the machine is about 7 yrs old so it maybe cheaper to replace than
Question about Ultima WF860 Front Load Washer
...Hotpoint WF860 washing machine?? it is possible but not a job that could be called easy, you have to completely dismantle the machine to remove the inner drum and then the bearings. It all depends on ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions