...transit bolts not removed. also can be caused by motor not winding up gradually into spin - usually a motor tach fault. most likely cause is transit bolts inbalnced load will cause it to shake also ...
Hotpoint WD 440 The machine makes a very loud banging noise when spinning on final rinse/spin. The transit bolts have been removed and the machine is on an even surface. What now? FIRST OF ALL THE ...
...the machine before commencing operation you have not removed the transit bolts!!!! do not use machine till you have done so as you can cause a lot of damage and it will not be covered under ...
Question about Aquarius WD640 Front Load Washer/Dryer
Hotpoint Aquarius WMA46 1300 , front loader Hi, I recently bought this second hand it is approximately coming upto 5 years old, however when it goes onto the spin cycle the drum seems to vibrate and ...
Question about Aquarius WD640 Front Load Washer/Dryer
hotpoint aqualtis aq9d 69 s washing machine and it is coming up error code f 18. i have not even been able to do the first test wash. help please Firstly remove transit bolts. Then connect hoses..Make
Question about Ultima WF860 Front Load Washer
...is it just balancing itself out or have the bearings gone?It has done this since we bought it. have you removed all the in transit bolts are the main springs all there supporting the drum ...
...Hotpoint WMF940P washing machine, cannot remove the transit bolts. Can you help? you'll need a ring spanner and give it plenty of force to release the bolts. I phoned the help line before starting as ...
hotpoint washers. if it is still noisy after checking all this the motor is on the way out or the drum. but most of time it is just the transit bolts and that the machine is not level. hope this helps
...transit bolts still in place as there were no obvious instructions saying to remove them. I stopped it after at most 2-3 minutes though. WIll it be damaged or will it be ok? Thanks. The transit bolts ...
Question about Aquarius WMA42 Front Load Washer
How do I extract the transit bolt spacers frpm a newly delivered Hotpoint Aquarius front loader washing machine? when you remove the bolts they should just drop down............. cheers
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions