...hot surface igniter) if the hot surface igniter is broken get a new one, if the spark plug don't spark, check the gap might be too big. see if the spark plug is grounded. poor grounds will cause ...
...Hot Surface Technology. Setting the pump pressure is always the FIRST place to start troubleshooting on these heaters. Here are some things that can prevent ignition even though there is fuel & glow: ...
...problem. Look for: always start troubleshooting fuel problems on a Hot Surface Ignitor heater by checking the pump pressure! restricted fuel filter air leak restricted nozzle Troubleshooting ...
...Hot Surface Ignitor type. I made the assumption you were inquirung about a Spark Plug Heater. Disregard the list if the heater is an HSI type---- troubleshooting is different. More troubleshooting ...
hot surface ignitor to light them...yours probably went bad... If you have a gas dryer. The most common problem with a gas and no heat is the ignitor going bad... Here is a tip that I wrote about that
...run troubleshoot and find the problem. Troubleshoot a spark plug type heater http://www.reddyparts.com/SP_tips.htm Troubleshoot a hot surface ignitor type heater ...
hot surface ignitor... The hot surface ignitors go bad frequently...you probably need to replace that... Here is a tip that will help you try to figure out why your furnace is notworking. BasicFurnace
rudd 2462gg14 blowing cold air hot surface ignitor glowing? Spark ignition? Inducer motor running?.....Too vague need more details to troubleshoot further....
...could have a problem with a safety switch, bad electrical connections, electrical short, circuit board issue, hot surface igniter issue....etc...........need to know the type of ...
Question about A O Smith Water Heater Hot Surface Igniter Ignitor 9003626005
why won't my A.O. Smith hot water heater turns on but wont light. lights come on and stay on, wont light. ...
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions
