Questions & Answers for: Mercury Grand Marquis hot start

...blow hot air in cold weather when i start A/C in cold weather ,no hot air come this problem is caused by a defective air temp control blend door motor, to replace this part the dash must be

Ad

start when egine is hot on a hot day. Once egine cools down the car will start. Problem dose not seem to occure during the winter months. Car was serviced at dealership where it was purchased but they

Ad

...hot, try hitting the starter while some one holds the key to start, it might start,but you will still need a new starter, replace it, I know it's easier said then done the way money is these

Question about 1989 Grand Marquis

1 Answer

coolant mixing with oil(milky,) air blowing hot air, thermostat going hot then normal then hot, smokes when car starts. what is my problem? cracked block or bad head gasket. find a good used engine ...

...hot so I disconnected the battery from the car. What is my problem? When you say it wont start, it wont crank even a little bit? any clicking? i would look for an issue with the starter if the wires ...

hot and start melting also. only abouy 2 inches of the wire has melted. what do i need to do??? you have a slow short in system this can cause a fire you need to determine what circuit it is and check

Question about 1997 Grand Marquis

2 Answers

...hot it wont restart till it gets cold again??? change air filter and fuel filter clean fuel injectors.faulty coolant temperature sensor will cause cold start problems. Check the battery like ...

...hot, it makes the engine get a signal to run lean, often too lean to start. Sometimes this error is picked up on the onboard diagnostics, but not always. Someone would need to unplug the O2 sensors ...

...hot, start melting, starter star making noise, replace battery, and the terminal cables get hot, start melting, killed the battery, head lights on, with the car off and the switch off. You have the ...

...hot wire, engine should crank over, and if your ignition on wire is connected to the hot wire, engine should start and run. (don't let the start wire touch a hot wire anymore), drive off and go

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...