Questions & Answers for: Kenmore too hot cold

...hot and cold water lines were switched (due to the previous homeowner installing everything backwards). We realized this after the first load came out steaming. I followed the pipes from the water ...

...hot water to the cold solenoid. or the wires have been interchange, the hot water wire was plug to the cold solenoid and the cold water wire was plug to the hot water solenoid. or hot water is still ...

...hot water on the cold/cold was When using the cold/cold wash the washer is actually doing a hot wash and sometimes a cold rinse...not always. sometimes it is a hot/hot wash and rinse even though i ...

...hot or cold. I have tried turning off the hot water tap and leaving the cold on. If I do this, then no water comes out at all. i have exactly the same problem and it annoys me that I now have to call ...

hot water on the cold setting but when I put the hoses back to normal and set the washer to the cold setting nothing comes out. This makes no sense to me. hot/cold selector switch replacement imminent

hot and cold lines to run hot water on the cold cycle setting. It worked for a few seconds and then went down to a trickle. Is there a temperature sensor on the fritz? kenmore washer hot or cold fills

...hot/cold, warm/warm, etc.) If I connect hot water hose to cold inlet and cold water hose to cold inlet, the hot inlet valve opens but the cold valve doesn't open after pressing start. I get the FH ...

cold is Hot Hot Maybe check that each hose is connected to the respective water bib, Hot to Hot on back of washer cold to cold?? It is easy to confuse these during machine hookup. (Worth a shot anyway

...cold and hot water come set to hot water and hot water come Ensure the hose's at the back are in the right places, Could be you or the fitters has put them in the wrong place. Cold water under ...

...Hot and Cold water supply lines are reversed. Shut the cold and hot water supply valves off and then remove and reverse the hot and cold water fill hoses on the washer and then see if it continues to ...