Question about U8147-900 WindTunnel V2 Bagless Upright Cyclonic Vacuum
Hoover Wind tunnel V2 Hoover WindTunnel V2 When I turn on my vacuum the roller brush will not turn and I cannot find where a belt would go. Please help. Either the brush rolls are bad, ends are bad, ...
Hoover Wind Tunnel My NEW Hoover 'Wind Tunnel # U 6637-960 will not work more than 20 minutes before the flat belt slides off the top pulley. Got new belts from Sears - no help If this is new, you ...
Question about Self-Propelled WindTunnel Bagless Upright VacuumVacuum
Hoover wind tunnel upright self propelled. U6473-900. Brush does not work. Heard it was a 'brush controller' problem and can be fixed. Please tell me how. Most likely the flat belt has stretched ...
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
...hoover with a wind tunnel. (12 amps) how do i fix it? Make sure the vacuum is on the carpet setting..the brush won't turn on the hard floor setting.. take the brush roller out of the vacuum and hold ...
Question about Company Wind Tunnel U53019 Upright Vacuum
...Hoover wind tunnel belts? How do you change the Hoover wind tunnel vacuum cleaner belts? If you turn the vacuum over there will be (4) screws that hold on the base cover for the roller brush. Remove ...
Question about Company Wind Tunnel U53019 Upright Vacuum
...Hoover Wind Tunnel vacuum cleaner runs for a minute or two then turns off. (It does not respond to the on-off switch on the handle.) It will start again after a few minutes. The side filter has been ...
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
...Hoover Wind Tunnel Self-propelled vacuum. I changed the belts because the brush was not turning. After replacing the belts the brush is still not turning what can be wrong? there are two belts on the ...
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
...Hoover wind tunnel V vac doesn't have belts so why aren't the brushes not turning String got caught up in the brushes now they will not turn It is driven my air. There is a turbine that drives the ...
Question about U8126-900 Wind Tunnel Dual V Bagless Upright Vacuum
...Hoover wind tunnel vacum. And how to replace it. My brushes are not spinning. Why aren't the brushes on vacum are not spinning around? Its usually located underneath the body of the unit, turn it ...
Question about U8126-900 Wind Tunnel Dual V Bagless Upright Vacuum
Hoover Wind Tunnel got plugged and very hot. We cleaned it out and now it won't turn on. Any ideas? Thermal fuse failed, motor brush gear stuck, switch failed, power cord... You will need to dismantle
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions