...hook up two sets of speakers. How this reciever is set up is there are left and right A and left and right B Only one 8 ohm speaker should be attached per outlet. if you exceed that your driving the ...
...hook up my 8 ohm speakers to this receiver You should have no problem with 8 ohm speaker with this unit as you would with the 6 ohm speakers. The 6 ohm requirement is only not to go under that value. ...
...8 ohm sub woofer? Right now i have 2 sub woofers hooked up to a class AB 2-4 ohm amplifier. The bridged positive and negative runs to the 4 ohm and then to the 8 ohm to end the circuit. how many ohms ...
Question about AP1200 Car Audio Amplifier
...8 Ohm speaker on an amp that can handle a 4 Ohm speaker will only play half as loud too. (Going beyond these capacity limits requries you to regulate the power output manually, or risk blowing ...
Question about - XP 5100 - 5000 Watt Power Amplifier with Subwoofer Output Amplifier
...hook up 8 ohm speakers to the 8 ohm terminals on your device. Some speakers are 4 ohms, and may not be able to handle the power if hooked to 8 ohm terminals, so be sure you have what they call an ...
Question about - XP 5100 - 5000 Watt Power Amplifier with Subwoofer Output Amplifier
...8 ohms. some speakers have wires that can hook up to more speakers. others use an external power source to boost the output of the speaker. I would ohm out the wires and find the closest thing to 8 ...
Question about - XP 5100 - 5000 Watt Power Amplifier with Subwoofer Output Amplifier
...8 Ohm speaker will work fine on it. If the speakers you hook up to it are lower than 6 ohms, it may work until you turn it up, then it will either shut down or burn out the finals. If you hook up a ...
...hook up the wires from your amp to each sub What it will be is 4 Ohms + 4 Ohms = 8 Ohms per speaker the 8 Ohms in parallel each speaker to the Bridged amp output using just the + from one channel and ...
...another 2 speakers in parallel and you get back to 8 ohm load. repeat the same process over and over and you can hook up to 32 speakers to the amp without needing the 70 volt tap. hope this
...hook up. this doubles the ohm output of the two speakers ) - turns 4 ohms into 8, 8 into 16, etc. the other way is known as parallel. (from the amp take the pos.side and make a "y" and send those ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions