Questions & Answers for: Mercury hood release

hood release latch is broken The release inside the car is broken and my battery is dead. I need to get into the hood to charge the battery but it seems the mechanic who replaced my fuel pump has ...

...hood. The release is slightly to the left of center. Good luck i hope this helps, please rate my response a fixya i remember most old model cars the hood opens from the out side look in front of car ...

hood release on 05 sable When I pull the hood release I can hear it work but it doesn't pop open so I can release the latch. After driving for a while it then opens. on each side of core suport under ...

The hood releases, but i can not open it While someone pulls on hood release cable have someone else pull up on the hood it should release.

...hood release I hear a low click but the hood seems to release but does not pop up any bit, so I am not able to put my finger under it to lift the hood. I tried to push back down on the hood and I can ...

...hood release, the hood doesn't pop up, have an assistant lift the hood while you're pulling the cable release. If this isn't helping, you can remove the grille out of the grille surround... look for ...

Hood release is intact. However, hood will not release. Is there a secondary release point? Yes there is, it's located just to the right of center of the hood(your left when facing front of car) feel ...

...release hood. Have to pull release and drive a bumpy road. take a close look at the male part of your hood latch. should be a heavy spring on it which pops the hood up a bit to allow you to get your ...

...hood. hood release doesnt work properly have an assistant pull up on the hood while you pull the hood release. it might pop the hood loose. if so, spray the latch mechanism and the hood release lever ...

...hood as you try to release hood latch if thie works for you, you can spray hood latching system and cable. work hood release from inside few times respray then you could use a white lith grease on ...