Questions & Answers for: hood key scanning

...hood) hold down the "TUNE" button and then press "1" Then use the numbers 1 2 and 3 to type in the last 3 digits of your VIN number. Quickly hold down "SCAN" button, the radio will power off, then ...

...Hood Keys scanning'' Hi, The F2 H2 error code refers to a faulty hood/light switch. This is a combonation board located just behind the buttons on the left panel. The part number for the switch board ...

hood Open the small box, and look under the lid locate terminals E1 and Te1. With a small paperclip, insert one end into cavity E1 and the other end into cavity Te1 Turn the key on Count the blinks of

...hood (Shut off when open trunk with key) or the trunk from inside vehicle. Since I had bought my Jetta the Remote Key is not working even after I had change the unit's battery and tried the ...

...KEY.It could be quite a number of things that cause it since all the doorsincluding the hood and trunk havesensors. If there are no codes relating to security then look for a mechanical failireif the ...

...hood. none say "mall" pgm fuse look under the dash Already went to dealer thats where i bought my spare key and the new remote but they said they don't program the remotes Your vehicle doesn't have ...

...hood power distribution center ? When you turn the key to start the ignition switch sends a 12 volt input to the PCM / ECM - engine computer . The engine computer will then energize the starter motor ...

hood fuse boxes. (yes ALL) ENG1 fuse not blown. if is spark and injectors all 100% dead. THEN SCAN THE OBD2 PORT IS NEXT. Buy the tool or rent it. scan now after cranking 5 seconds, release key and it

HOOD, DAY OR NIGHT AND WHAT THAT DOES AT NIGHT IDK. BUT FUSES ALL GOOD TESTED SO SCAN THE PCM./BCM PORT, OBD2, TOOLS WORKS LCM PAGE1 OF MANY. https://imgur.com/a/Ih5l2Jd It sounds like there may be an

...hood is open and car running? My remote start doesn't work properly because the lights flash, so it receives the signal from my key fob but won't start. Question edited for clarity. Question moved to ...