Questions & Answers for: Mi T M honda generator runs shuts

What do I use for oil in motor? I always use synthetic oil in my small engines, and recommend it. Use 5w-30, 5w-20, or 10w-30

motor will not start. Plug is igniting has spark. seems to be to much gas. [email protected] Hello, First thing to check would be your air filters make sure not blocked as this will act as the choke ...

I have a Mi T M job pro 3500psi pressure washer that may have a clog in the nozzle, how do I release the pressure in the line? All the pressure fittings are stuck (probably from the pressure in the ...

...& stop Hi. I have no clue what I am doing. I have a MI-T-M (i think) pressure washer with a Honda GX340motor. It's 11.0 HP, 3000PSI, 3.5 GPM, model # CW-3004-3MGH. It was given to me when my ...

...Honda EM5000S generator issue. Will start easily, run for a few seconds, then cut off. Problem just started. Checked spark plug, air filter, fuel line. All fine. Any ideas would be appreciated. I ...

it starts with the switch fine but when i let go of the key it cuts off Check for faulty low oil sending unit or oil level low or dirty oil (some generators have a fuel cut-out solenoid at the carb ).

i need a owners manual for a pressure wahser GCV 160 from honda the serial number is GJARA 2230829 MiTM will have that. See mitm.com   Honda makes the motor but not the pressure washer. 

...asembly from the small engine housing/flywheel cover. Usually three bolts hold it on. 10mm on Honda's. Pull the remaining rope thru the exit hole if possible. Otherwise, fish remaining rope ...

How do I replace pull starter rope? remove the pulley housing cover.Remove the remaining rope pay attention as how its' threaded.Loop the new rope exactly as the old one.That's it

I have a mi t m 7500 generator, how do i fix it to run my house? unless you are a master electrician this becomes very complicated. First you need a generator that is large enough to power everything ...