Questions & Answers for: honda engine pressure washer stalls

Honda GX390 engine. Unfortunately, it stalls around the turns, acceleration and deceleration. Thinking it is the carburetor? Any suggestions? The engine is brand new. I believe its the the oil sensor.

...hi, you are making the engine stall with having the unloader valve screwed to far down i would say, try dropping the pressure on the unloader and then try it. the unloader valve could also be

...pressure now. tried adjustment screw, engine stalls hard to pull start also, unless water off first.no leaks found, any idea. if you bought a new pump make sure its the correct type then check for a ...

...When just started, the pressure won't rise with the wand. When the trigger is applied for long periods of time (1 minute) the engine stalls Thought it was a free advice web site? Scammin'

...Honda engine runs smoothly without wand, but stalls when wand is attached. If the pressure unloader is not working correctly and/or  the nozzle is partially clogged with debris, the engine will ...

...Honda engine on NorthStar pressure washer to run. Cranks and runs, but stalls when trigger is depressed to spray. Could be low water pressure I have found. Also, I purchased a can of "stuff" at Lowes ...

Was working fine, for about an hour. Stalled checked and fuel looked low but not empty. Filled just in case and the engine started. Ran about 5 minutes then stall as out of gas. Restarted using choke ...

...engine bogs down and stalls PROBLEM 2 when started water does not exit the high pressure nozzle but when I switch it off i see that the water path through the PW is not blockedas stated above i made ...

...honda xr2600 pressure washer stops running when i pull the trigger check for a blocked main jet in the carby the principle is that when the trigger is released there is no pressure in the pump so the ...

...pressure wand the engine runs fine as soon as pressure builds (stop spraying) engine stalls the pump has an unloader valve it has a check valve at the high pressure output port where you connect your ...