Questions & Answers for: home ice maker freezes wont

...Ice Maker The ice maker, located in the door, fails to make ice. The area is cold (certainly cold enough to freeze) and the 'fingers' that move the ice through the tray work. LG customer service had ...

...ice maker out of sync? Too warm? I have a Roper (RT21LMXKQ04) with ice maker which use to make perfect ice. Lately it appears to be heating too soon and melting the ice too much before the "arms" can ...

Ice maker grinding sound Ice maker works but makes repetitive grinding sound, regardless of ice maker arm position. How can we stop it? I found I get a odd clicking noise whenever the icecubes freeze ...

Ice maker stopped making ice. I emptied ice holding tray and since then, if will not make ice. I adjusted arm in hole correctly. Arm is down and is in correct position to make ice. Still no ice. ...

...Ice maker 106.565424 Kenmore by Whirlpool sxs water in the door. Ice maker stopped working. Checked line, it is clear. Front water working, no water in ice tray. Have seen arm moving. The water ...

ice maker is not working 1. Check that Bailer Arm is DOWN 2. Put finger up in Ice Maker Mold and check to see if there is Water Filled in the Ice Cavity (just where the ice is pushed up and out of the

...ice maker makes impure ice but the water is crystal clear and good. replaced filter and cleaned ice maker tray ect.... no change. Is there a way to sanitize the water line to the ice maker? what you ...

...home position. 6)Verify that the motor does not remain on after being turned off. 7)Proceed to the freeze cycle. SERVICE DIAGNOSTICS TEST MODE During the first 15 seconds that power is first applied ...

ice maker not working Hello, When we moved in to this house two years ago I noticed the arm on the ice maker which controls (on-off) the ice maker is missing. So every time we needed to stop the ice ...

...ice maker freezing up ice maker freezing up Hi – Is the wire signal arm in a stuck position or has any ice cubes stuck? If so, try turning it off and remove any ice cubes stuck to the wire signal arm ...