Questions & Answers for: Jeep Cherokee hold job

...the clips or lose them) keep the lines upright to avoid draining the tranny fluid. Undo the 2 bolts holding the fan shroud, slowly and gently push the shroud towards the motor (do not bend the tranny ...

job. Just remove the 4 screws that hold the plastic head light frame. Then remove the screws that hold the metal frame that holds the head light in place. Make sure that you DO NOT move the head light

...job, someone will need to hold the hatch up while someone changes the shocks. good luck! Those are easy to replace and available at most auto parts stores. Some auto parts stores will be nice enough ...

job. Disconnect the battery, then remove the two bolts that hold the starter to the bellhousing. Lower the starter and unbolt the wires on the solenoid. To install reverse procedure. be careful not to

job easier, you may have to remove some fuses or relays because the blower motor will not come out with fuse box in the way. remove wiring connector to fan. then take out 3 or 4 screws that hold it in

...consist of first disconnecting some wires leading to the fans. Secondly, removing any small bolts holding it on, (may be 2 bolts at the top, and 2 at the bottom, of the radiator), Then usually you ...

...hold them in place of the mounting studs and hit them with your palm to pop them back on. Be sure before pulling them off, that you remove the lamp, plug/power plug /and lamp lock. If your talking ...

...job. Remove the wiper arms from the studs (held on by swing out stainless retainers at bottom of the arm on the stud) Then remove the cowl (six or so screws and it lifts off). remove the screws that ...

...job? How much should something like that cost? Thanks, since the door is open,, hold the handle in the open position and try and move the little hook looking latch , it may have just moved into the ...

hold a rag over the end of the filter you are removing the line from to prevent the excess fuel from spraying you and everything around you. For a beginner it will probably take you 20-30 minutes, but