Questions & Answers for: Coleman hold

wont stay lit I have a heater that wont stay lit after you hold the pilot for the minute or two that they say I even hold that pilot down for 5 minutes and it wont stay lit can anyone help me go to ...

...against sanders with excessive force. # Sand only on the downstroke side of a disk sander. # Do not hold small pieces by hand. Use a jig for pieces that are difficult to hold ...

...friend put pipes together using a vasaline like sealant for the black pipes. The pressure did not hold. The pipes have to be taken apart again. WHAT IS THE BEST WAY TO SEAL OFF BLACK PIPE SO IT

...what the two clips on the side head band were for on the coleman headlamp? I'm guessing either to hold the wire or to clip on somewhere? you are correct they are for holding the wire to avoid ...

...off cover need to be removed to access the pilot. To light the pilot, turn the knob to pilot and hold down while lighting pilot. The pilot in straight back inside the hole about 10 inches. Use a ...

...that you put the match in to reach back far enough to light it. Just turn the knob to pilot, and hold it down and you should be able to hear and smell the gas. Light the match and stick it along ...

the gun part of the wond has a hold. will I need to replace the hold gun section? If so is their a replacement? Hi, if the gun section is just leaking, then you can replace the washers inside; ...

...is a red switch on the gas valve. Some models require you to slide the red switch to the top and hold. Holding is allowing gas to the pilot. You have to stick a long match,grill igniter, to stick ...

...put back in. help? female with trouble and wanting to camp this weekend Sounds like the motor also holds up the top. can you try to use something loke a broom stick thick piece of wood to hold up

...coleman heater will light then when i turn it to high med or low it goes out it burns as long as i hold to light position it burns as long as i hold the switch to start position the i move it ...