replace a burned out one? The Head Lamps for the "Low Beams" are tricky but they work just like the High Beams do. You have to reach around the Headlamp assy (toward the Outside of the car) and locate
I want to change the oil pump in a 2000 Acura RL I had a pinging sound start on my Acura that was so loud that I thought the piston where going to come through the hood. I had oil and water and it was
...the small service port this is wher u charge the small ac line/hose has the large port this is the high side the high side is located on the drier infront of the condensor and the low side is in
...have blogged about this...is there a fix? It is dangerous to drive at night. I have to have my high beams on all the time to see street signs, deer on the side of the road, people walking, etc. ...
My air condition does not work at all and the heat only works on high what could that be? Two separate issues...but the heat only working on high is caused by a bad blower motor resistor.
...connections) 2. Pump and its relay ( Are they in good condition?) Weak power to your pump means high resistance on power line make significant voltage drop that cause lower pump ...
...ping) or (engine knock).Try the regular gas(dont completely fill car) and take notice under hard acceleration if engine makes a pinging noise.If pinging happens then add some high octane gas to ...
...out, one will run to the front of the car (smaller of the two lines) this is the discharge line (high Pressure) along this line will be a valve before the condenser coil. Follow the large line
transmisshion noise transission makes noise at 30-45 mph change fluid ,into high milege trans fluid
Question about 2002 3.5RL
Fan motor on high for 1sec. Then to low repeats,never stays on more than 1-2 seconds Check resistor for blower motor, also could be blower motor or auto controls failing.
Usually answered in minutes!
144 Questions
134 Questions
136 Questions
108 Questions
91 Questions