Questions & Answers for: high limit

...high limit Could the high limit be getting weak? Hi, sometimes high-limit goes bad, but why, check to make sure you're not overloaded with produce, check to make sure freezer has good ventilation, if ...

...high limit thermostat is defective. need to know before ordering part Hi, you'll need a ohm tester (multi-tester) you will have to remove / disconnect wires from hi-limit, in normal room temperature, ...

...high limit trip. Most, if not all, furnaces have high limit switches that keep a constant check on the temp inside the furnace or air handler. On most systems, once this high limit switch has been ...

...high limit switch issue? It might be the high limit, but it could also be the roll out switch or the flame sensor. Start by ohming out the simple switches the high limit the rollout if the are good ...

...high limit thermostat. It depends a lot ofn what type of control you have on your fryer. If they are all mechanical controls, the high limit may need to be reset. Open the front door of the fryer. ...

...high limit switch is kicking off the element within 2 mins of running. So heating element heats up red hot, then clicks off after 2 mins. I have continuity readings on the cut off, dryer cycle ...

High Limit switch corrodes over time. Then it causes a High limit fault. Is there a cheaper place to get the high limit and low limit switches? I see them for $30 to $40 on the internet. bad header ...

...high limit relay. Have to pull main breaker to get to reset. I have already taken the entire furnace apart and cleaned it (completely, motort, evap coil cleaned, filters, etc, completely cleaned and ...

...High Limit Fan On/Off Settings for Tappan Gas Furnace I bought a Combination Fan and Limit controller to replace the original controller on an old Tappan model SGUF140D48E7, s/n 77 19739 140,000 btu ...

...high limit switch for a Pitco VF35-S Frialator The pilot flame goes out when the thermostat knob is moved from the off position to the desired temperature setting. Could this be caused by a faulty ...