Questions & Answers for: heating pads Water Heaters

Question about Whirlpool Water Heaters

2 Answers

My pilot light will light, but will not stay lit? I have a gas whirpool water heater aprox 1 1/2 years old.Thisis the first time we have encountered any problems with our appliance. Once the flame has

Ad

Question about Tankless Hot Water Heater Rtg-74pvp-2 7.4 Gpm

1 Answer

Heats up the rapidly decreases within in minutes. I have a Rheem tankless water heater and it heats up initially to the proper temperature and the cools down immediately. I did the visual check the ...

Ad

Question about 50 Gallon FVR NATGAS Water Heater 6YR 22V50F1

3 Answers

pvs50-36fv just looking to find the manual on-line and to see the problem codes in a print-out. We have a similar problem to: By acmesser on Oct 04, 2010 Rheem Power Vent PVS50-36FV..Constantly goes ...

Question about 50 Gallon FVR NATGAS Water Heater 6YR 22V50F1

1 Answer

Have an LP gas water heater with White Rogers control that cycles on and off 3 times before remaining on. Water heater is 5 years old with forced exhaust. Heats water fine once it remains on. Do you ...

Question about Paloma 7.4 Series Ph28 Outdoor Tankless Water Heater

1 Answer

I have a Model PH-28ROFN. The control pad reads 120 as it always has. When I turn on the faucet the code C2 11 flashs in sequence. No hot water is available. Any ideas please. Jerry Averill Before ...

Question about BTH-199 BTH-199 100 Gallon 199,000 BTU Cyclone Xi[REG] Commercial Gas Water Heater

1 Answer

igniter is not working Try removing the igniter. (First turn the heater off) There is a heat sensor rod on the igniter. If it is blackened use fine sand paper or a scotch brite pad and clean

the heating element, a pad, separated from the galvanized base. How, what glue do i use to re-glue the pad to the base? mine did the same thing I am going to use a high heat construction adhesive

Question about 7953 AquaLink RS One Touch Control Panel - White

1 Answer

Jamdy RS Shuts off heater too soon I have a pool and spa controlled by a Jandy RS One Touch Controller and the spa won't get hot enough. I set the temp to 103 on the one touch control pad and ...

how do I make heat tape to wrap around pvc pipe & heat under my planting flats for starting seeds OR for wrapping the chickens' waterer? Thanks I started seeds on a pet warmer pad that I got at ...

Question about 7953 AquaLink RS One Touch Control Panel - White

1 Answer

water not heating Hey James,, There is a couple reasons... the heater controls have quit working, the upper and lower heating elements have gone bad,,, the water heater breaker has tripped,,, Most ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...