Questions & Answers for: heater torch problems

...heater has sat for approx. 2 years. when last used it worked fine. when i plug it in the spark plug fires and sometimes it will ignite for a few seconds an then shut down. the spark plug also quits ...

...heater try placing bright torch under the machine and have a look in the drum to confirm, a bright torch should shine through the plastic and give you an idea of what it is. also check the holes in ...

...torch!. We have managed to get it lit about 4 times in 4 years and it is very frustrating! Any help would be appreciated. turn off propan and heater. Undo the connector hose. then rehook hosewith ...

...Heater turns in to a blow torch Hello. I have a TT30G heater that after running for a short time all of a sudden it gives off a blow torch noise and the flame stops glowing. The only way to stop this ...

heater not getting hot water. Temperature dropped to 17 degrees overnight and my propane is only 10% full of a 250gal tank. We are getting cold water fine, but nothing out of the hot. What is problem?

...torch and you will see the levers operated by the motor for the heater controlls wich are coloured orange white and grey but may be other colours, lubricate with wd40 lightly and check there is no ...

torch and use a 3/4" pipe nipple to try to cut a new thread. If water heater will not drain ... put washing machine hose on water heater valve - run water hose between washing machine hose and outdoor

...heater from a guy he said it worked fine when he gave it to me. I hooked up a 100 pound tank and fired it up the pilot light flame acts like a blow torch. Then it burns for 5 minutes or so then goes ...

My torch ignites and starts the flame but then shoots to a like 3 foot high regular Flame .what is the problem? sounds like you have a bad regulator on it . not knowing what you call a torch

My Martin vent free fireplace pilot light is a foot long . Looks like a torch light. Do I need a new pilot assembly Model UF29BE liquid propane It is That long you may have a pressure problem with the