Questions & Answers for: Northern Tool heater plate

wickes how do you change out a wick in a kersun heater I went to a site that has questions and answers about a kerosun heater. from what I gathered, instructions on how to replace the wick are ...

dyna glo RMC95C6 kero heater bought this unit last year new at end of season. hasnt worked right since i bought it . really hard to light . when it does light only part of wick lights. and smokes like

kerosene heater will not wick up fuel from tank properly After 1st lit starts to burn then slowly burns out. I Have completly dissasembled,cleaned all pts+lower mop like wick and replace upper ...

heater and I have forgotten how to use it. I can't find the manual. It says to "set the automatic extinguisher by pushing the set lever to the left until it locks." WHAT OR WHERE IS THIS LEVER??? Mine

the pilot light on my gas water heater continually goes out. I can re-light the pilot and get it going. The gas burners goes on runs for awhile. I'm assuming when that when the temp hits the desired ...

thermastic knob does not turn. Brand new out of thermastic knob does not turn. Brand new out of box return it to store

...will solve the problem. Any ideas. I can purchase a new one for $109. You can pick up a ceramic heater heaper and not have to hassle kerosene, wicks or fumes, and ther last ...

...height and it has been dry-burned numerously. The kerosene (K-1) works fine in the other 'kerosene heater' I have and I always purchase same from the same supplier. Once it has been burning for an ...

My radiant Kerosene Heater wick will light but then the wick stops burning in certain areas around the ring. It is always the same spots. I get the K-1 from the same retailer every time. Is it time ...

heater? Remove the base plate from your Comfort Glow heater and expose the fuel tank. Lift the fuel tank out of the heater and set it to one side, well away from the heater. Note that the fuel tank is