sealer skin lightly and then put the housing in place making sure that the thermostat had remained seated during the installation. If it had come loose and you try to tighten the bolts, you will crack
...to put it in myself without going to a workshop. get one from a salvage yard and splice it in. Just solder the splice and use dual wall heat shrink tubing that has sealer in it to make it ...
...sealer the car started up fine no shake but then started to over heat after around ten minutes of driving and even worse when the ac is running. I have changed both upper and lower thermostats, and ...
...heat just comes and goes Be verry careful with this kind of problem. Make sure you are not losing coolant somewere like through the exhaust through the head gasket. Before hot but close to opperating ...
...heat "sync" . Youll need a little gasket sealer and a couple sockets and a screwdriver. Here are some generic instructions to help. Drain the coolant from the radiator into a proper container. Take ...
...heat?? Possible problem: Check the radiator to make sure you're not low on water (coolant). If the coolant level is OK, the most likely problem would be that your thermostat may be stuck open (very ...
Question about 2006 Xterra
...sealer I know of. You can buy it on Amazon if you can't find it in your country (Aussie?) old rusty water indicates that there was never any coolant additive used that means that the radiator cores ...
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,309 Questions
1,122 Questions
1,306 Questions