...until contact is made with the boss on the head. While holding the sensor in this position,install and tighten the retaining bolt to 12 Nm (105 in. lbs.) torque. Attach electrical connector to
...head. While holding the sensor in this position,install and tighten the retaining bolt to 12 Nm (105 in. lbs.) torque. - Attach electrical connector to sensor. Good luck and hope this helps my sister ...
...bolt torque down for a 1996 dodge stratus 2.4 liter dohc Cylinder head bolts for 2.4 doch in ft\lbs Step 1 .....................................................................................25 Step ...
...Head Bolt Torque sequence ------------ | 10 6 2 3 7 | | 9 5 1 4 8 | ------------ Step: 1 - Torque to 25 ft/lbs Steps: 2 - Torque to 50 ft/lbs Steps: 3 - Torque to 50 ft/lbs Steps: 4 - Turn 90 ...
Head Bolt torque specs for a 2005 dodge stratus 2.7L STEP 1 TORQUE BOLTS 1 - 8 - 35 FT LBS STEP 2 TORQUE BOLTS 1 - 8 - 50 FT LBS STEP 3 TORQUE BOLTS 1 - 8 -50 FT LBS STEP 4 TORQUE BOLTS 1 - 8 - PLUS 1
...front head lights The headlights are super easy to replace, there should be just a couple 10mm bolts of maybe t20 torque srews at the top of the lights take them out and the headlight should fall
...bolt head as you loosen the retaining nut with a ratchet and socket.Pull the control-arm ball joint off the steering knuckle arm. You may need to use a Pitman arm puller to free the ball joint.Finish ...
...head bolts THESE ARE TORQUE TO YIELD BOLTS REPLACEMENT ARE REQUIRED (one time use) 4 step process bolts dipped in oil and clean thread holes 1st 25 foot lbs 2nd 50 ft.lbs 3rd 50 ft.lbs 4th turn ...
Usually answered in minutes!
1,417 Questions
1,121 Questions
924 Questions
772 Questions
621 Questions