Questions & Answers for: Chevrolet Silverado 2500HD head bolt

...bolt, right now its hanging from firewall, the length of the wire is less than 24" long. the vehicle is a 2003 chevy silverado 2500 hd with the 6.0 Wire could go to rear of cylinder head. Going from ...

...the extent that one is breaking bits to free the bolt - and no, it was not due to rust. And why on earth are there torx head bolts on the Chevy anyway? I will go back to Ford if I ever get the

ONE OF THE ENDS OF THAT PIN OPOSIT OF RING GEAR THERES AN 8mm SMALL HEAD BOLT ( TURN RING GEAR TO CHECK OTHER END OF PIN ) REMOVE BOLT PUSH AXLE IN REMOVE HORSE SHOES CLIP IN 3rd MEMBER SLIDE AXLE OUT

bolt head and sometimes heat helps (unless you aren't careful and start a fire or melt something you need). Once the bolt moves a little, keep working it in both directions and moving it out further a

...block) only has to be removed if you're replacing the caliper, and in that case unbolt the 2 hex head bolts and remove the entire

I would like to replace the headlight assembly of a 2008 Silverado. I've located 3 bolts and removed them but am unable to remove assembly. Is it possible to replace the head light assembly without ...

...like its leaking from lines back right hand top side of motor. hoping there is a line break, not a head issue. Help please alum heater line is cracked next to the weld where it is bolted on been ...

...the exhaust manifold bolts/nuts rusting off. if you are lucky you can get the partial stud out of head if not they need to be extracted either in truck or heads off and extracted/drilled and ...

...head bolts (11,12,13,14,15) to 30 Nm (22 ft. lbs.). Begin with the center bolt (11) and alternating side-to-side, work outward tightening all of the bolts. NOTE The cylinder head gasket displacement ...

...the block like the pictures ive seen...I have the 8.1 liter big block behind drivers side cylinder head,bolted to the block. Hope this