...HDD (80GB), now its Full. My mother board is of Gigabyte 81865GME-775. Mother board has two ports of SATA 0 & SATA 1. I have tried in both but system is not able to detect the new hard disc. Is it ...
Question about P4VMM2 Motherboard
...HDD Led on the board. i dont know where to put this things to the board [10][ 9] Pin 1 = +HDD pin 3 = -HDD LED [ 8][ 7] Pin 2 = + POWER pin 4 = - power LED (SPD) [ 6][ 5] Pins 5 & 7 = reset [ 4][ 3] ...
Question about Slot 1 P6BX2-A (147010300187) Motherboard
...hdd led spk power reset wires I have to know where they go on this main board as the old one was labeled different the pins seem to be laid out different than the old board first from left to right ...
...hdd and power wires in the right spot on the board itself can you plz tell me where they go or send me a wiring diagram to my email or if you can think of any other reason as to why its doing that i ...
...HDD 7200 RPM (IDE) work with my board? -and last, a video card: SPARKLE 7300GT 512MB 128bit; will all these hardwares work with my board? would you mind reccomending some if one of these dont work.. ...
Question about ECS L4VXA2 (CDL4VXA2) Motherboard
board to have power and thus the computer to power up.. need to see configuration for this..hdd power.. led power..reset power Hi there. Get a strong flashlight and a magnifying glass (if you have one
...board is p6stp-fl of elite group I want to up grade to 160 gb hdd from 4o gb hdd Yes you can upgrade it to 160 GIG of hard drive so just simply replace the old one and of coarse you need to install a ...
...BIOS settings? ECS is not known for excellent quality - if you have a bad board hopefully it is still under warranty. hi, you only need the raid driver.. download it..your sata HDD will view. ...
HDD?, if this fails to, then the IDE/SATA controller on the board or the traces that link the controller to the southbridge may be damaged, if you have one, or can afford one, try a new board, if this
Question about MCP61M-M3 Motherboard
...board only takes 40 pin cables. I note that if I remove the cable from the IDE HDD(which was going bad)on IDE 0,the system boots fully(to DVD,that is).Badd HDD? I installed a different OS the other ...
Usually answered in minutes!
319 Questions
194 Questions
139 Questions
112 Questions