Questions & Answers for: harman kardon signature

Amp problems Have owned this amplifier for 7 years and all of sudden it will not stay on. When switched on by the signature 2.0 preamp the amp will power up and come on for about 10 to 30 seconds and ...

...Harman Kardon Signature 2.1 DTS version outboard processor/preamp, and many others on the market by different manufactors, Run the discrete audio outputs from the Processor into the AVR 5`s 6 channel ...

What is the latest sofrware version for the 2.0 preamp and how is it obtained. Can I check my operating version? I just emailed HK asking where to get the software update. As for checking your current

Have intermittant protect, usually during start-up(until @operating temp.),ocassionally for no aparrent reason.(never clipped) Cold solder joint? This is a symptom of either a poor solder joint or a ...

I just hooked up my harmon Kardon 2.1 amp after moving and when I fired it up instead of warming up and the indicator light turning green. It turned orange and pulsed red. I could here the amp relay ...

my unit doesnt have dts only dolby digital. is it possible to apgrade software? The manual I found at retrevo.com talks about an upgrade that enables DTS (page 34). I take the eeprom replacement to ...

...Harman Kardon Signature 2.1 is a final amplifier. This means that you have to use either one pre-amplifier to provide audio signal to Sig. 2.1 or your receiver must have an audio volume control. ...

Harman Kardon Signature 2.1 amplifier that wont start. Its LED flashes red and yellow indicating that something is wrong. Does anyonehave any idea why? I work on power amplifiers and I can offer a few

amplifier doesnt turn on at all The Signature line was always an HK high end line. If it won't turn on at all, there may be a power supply issue. If it turns on, but you have no sound, your amplifier ...

Most Recent Harman Kardon SIGNATURE 1.0 Amplifier Questions & Answers Do you have a question about this?