Question about 2000 Wrangler
thumb switch on automatic transmission won't go in so I can shift When the jeep is in park, I can't get the thumb switch to go in so I can shift. I hear the brake switch underneath the instrument ...
Question about 1997 Wrangler
I'm trying to wire a dome light into a 1997 jeep wrangler (TJ) I am trying to figure out what wires to splice into off of the light switch. When I hook up my leads I found two wires that are ''hot'' ...
fastener a few threads on and repeat for other side. P.S. to remove the old links a sawzall is VERY handy
...lights do work. You can buy a test plug with led lights that plugs in both male and female, real handy for checking
...I do love it. Redding, CA. best bet is to shop around to find the best deal,, or check out all the handy guys who may fix it cheeper just dont go getting milked paying meger bucks for an easy job ...
...switch, BUT, does it have a resistor bank? That is, how does it reduce the speed? Many systems use resistors to lower the speed. Burnt or bad connections can cause this as well. You can test the ...
...switch mounted on the brake pedal lever. Easy to replace if you are a handy fellow. Disconnect battery ground cable. Disconnect electrical connector for stop light switch. Remove bolt and lock nuts ...
...handy with a test light, you can verify the switch is good or bad, or take it to your favorite mechanic and have him or her verify. good luck. The switch gives lol. Jeep has a common problem with bad ...
...further. crank angle sensor, collision sensor may caused a halt like that. keep a fire extinguisher handy when your working with fuel system and not in the ...
I have a 1995 YJ with 2.5 engine 5 speed man trans. I am trying to find the neutral safety switch if it has one Thanks Click image for zoom... Fig. 1: Park/neutral position switch and manual lever The
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
339 Questions