Questions & Answers for: Bunn handy switch

...handy the problem is a defective thermal switch on the warmer. Unfortunately this would only be accesable from the bottom of the machine and since the machine holds about 2.5 quarts of water it can ...

How to change a start switch, and a lighted bottom element switch on a Bunn Omatic 3 station coffee maker (with a hot water spout on the side) Unplug your brewer, take the 2 screws off of the lid, ...

...were on recall. Be sure to have the "Date Code" (on the bottom of the machine) and the Model number handy when you call. They replaced the older one and are sending parts for the newer one at no ...

...switch by itself. If you are handy with a small screwdriver, unplug the machine, take the top plate off and check to see that all the wires are connected to the elements and to the switches. If you ...

using Bunn CTF15 autofill connection to water supply...pot continually overfills...can water level/ volume be adjusted? The solenoid is leaking, replace and the problem will be gone. .CAUTION - ...

...the spray head and use the spring to clear the water tube (from tank to spray head) if you are handy, remove the top cover and use the spring to clear the hole were the water goes down to the ...

handy with a soldering iron, you can get a replacement switch (in your choice of colors - think about that!) at any electronics store, perhaps even Radio Shack. It's best to remove the old switch &

adjust bunn coffee maker water level To adjust the brew volume/batch size you will need to access the main circuit board behind the front panel. Isolate the machine before removing panels. NOTE: Check

You should be able to find a local Bunn distributor for the part required. Have your serial number handy

I have A bunn Ultra slush machine. When plugg it in the power outlet, the compressor start getting on imediately and the power switch is off. What could be the problem ? The switch has failed and is ...