Questions & Answers for: Jeep handle lock

Question about 2002 Wrangler

1 Answer

...handle try pulling on the rods to unlock the door then open it, once the door is open remove door panel 2 screws at bottom and just pry up on the soft upper grommets if it a half door reomve door ...

Ad

...lock works fine but the rod to the door handle unscrewed from the inside of the door. it just hanging loose. How do i get it back in? Full doors. You will need to remove the door panel. Most use a ...

Ad

Question about 1995 Grand Cherokee

1 Answer

...lock control, but when you pull up on handle, nothing happens. There is no handle on the inside to open, so I guess I am looking for directions on taking off the inside panel (without breaking ...

...a 98 cherokee limited and had a similar problem when I purchased it used. It would lock and unlock, but it wouldn't open. To first open it I had to push the handle down while I pulled the latch

...handle exactly in the center (same place the key lock is only on the drivers side) Use a quarter inch bit. If you get it right, you can remove the handle assembly and get to the rods that work the ...

Christmas trees" or clips and just pulls out. Spring Broke in handle just take the one or two screws out of handle and move towrads u there are two rods one for lock and one to open door done in 15min

the entire assembly is being pulled out and you have to press on it, to hold it in place, while pulling on the handle. Make sure to hit open on the power lock a few times before trying this. Good luck

Question about 1998 Grand Cherokee

1 Answer

...handle assembly (black plastic around the pull handle) while at the same time pulling on the handle to open it. Make sure to hit open on the power lock a few times before trying this. Good

Question about 1998 Grand Cherokee

1 Answer

...lock it in. Once the handle is in place with your "C" retainer in place, slip the same removal tool behind the handle and between the door panel and push forward as you gently turn the handle until ...

...you wind up the tyre until it is tight. To undo the clutch and lower the tyre simply turn the crank handle as it letting it down. Overcome the initial tightness and then it will lower as you turn the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...