Questions & Answers for: grounding rod

Ad

Question about Radio Communications

1 Answer

...grounding rod in the ground from radio shack or local two-way radio shop. Then connect the grounding rod to your mast. You can get a polyphaser from your local two-way radio shop this will connect ...

Ad

Question about D25900k Heavy Duty Demolition Hammer Breaker

1 Answer

Ground rod driver Sizes types and Mfg. of Ground Rod Driver that fit D25900 Type 2 Demolition Hammer PGD 97-0603-625 (for 5/8" rod) PGD 97-0603-750 (for 3/4" rod) Driveze Corp. 30 Possum Circle ...

Ad

Question about Guardian HTS Transfer Switch 200 Amp, 120/240 Volts

1 Answer

...grounding rod is fed by an old green colored braided wire. Where I start? Nono First check that you have good continuity on the earth conductor from the 200A switch to the grounding rod and that the ...

Question about Guardian HTS Transfer Switch 200 Amp, 120/240 Volts

1 Answer

Ground rod placement I have a circuit breaker panel in a large garage that needs to be grounded. The panel is near the center of the garage. Can I drill a hole in the slab under the panel and put the ...

Question about D Qo 100 Amp Breaker Box Qo120m100 Indoor Panel

1 Answer

...grounding rods and water pipe from my disconect boxes. First of all, the SQD QO120M100 is a Main Distribution Box. The ground wire from the ground rods and water pipe can be attached to either of the ...

Question about D Qo 100 Amp Breaker Box Qo120m100 Indoor Panel

3 Answers

...grounding rod for a typical residence. The grounding connections should be continuous from meter / service entrance throughout the building -- your meter is grounded to the rod, the breaker panel is ...

Question about D Qo 100 Amp Breaker Box Qo120m100 Indoor Panel

1 Answer

I have a hilti te52 and they were pounding a ground rod in with it and the end in the chuck mushroomed over and now we cant get it out what do we do. the only thing you can do is try and tap the ...

Question about (3E133) InfraRed Heater

1 Answer

dayton (3E133) hooked up wont work at all gas on 24 volts to unit polarity correct. nothing happens. Whats wrong. The 3E133 (or similar) Infra-Red Heater with correct voltage to the circuit board ...

unit does not do anything gas on and correct voltage to unit The 3E133 (or similar) Infra-Red Heater with correct voltage to the circuit board should produce a spark at the spark ignitor rod within a ...

Question about D Qo 100 Amp Breaker Box Qo120m100 Indoor Panel

1 Answer

...rod First of all you need to have two grounding rods outside the house. Usually they're 12' long and have to be driven in 11-11.5 feet... but different particulars apply to different states and local ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Radio Communications Experts

eradiostore
eradiostore

Level 3 Expert

1658 Answers

Anthony Ward
Anthony Ward

Level 2 Expert

397 Answers

Brad Brown

Level 3 Expert

18438 Answers

Are you a Radio Communications Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...