...problem being that the back and forth motion of the agitator starts the loud grinding noise, it will likley be broken gears in the transmission. The single most expensive part in the washing
Question about WVSR1060A Top Load Washer
...grinding noise. Spins okay. Washer fills, but when it starts to agitate it makes a terribly loud grinding noise. Removed all the clothes, still made that terrible noise. Switched to spin cycle and it ...
Question about Ultimate Care II LSQ9549L Top Load Washer
grinding noise. What caused the noise and what should I check to see if there is any damage I should be concerned with? Thanks for your help. Russ Cerminaro Email: [email protected] is it possible
...grinding noise durring the spin cycle. The noise got progressively worse until it suddenly stopped as did the washers ability to wring clothes dry durring the spin cycle. I checked the rubber tub ...
Question about 22422 Top Load Washer
grinding noise I have a Kenmore top load washer, Model 110.20922990 that will not agitate or spin. When in spin cycle, there is a grinding noise. Please advise. CHECK THE MOTOR coupler located between
grinding noise while agitating. Put tennis shoes in washer, and within a few minutes in wash cycle, it started making a grinding noise during agitation. Didn't sound good, so turned it off, got shoes ...
...noise during the wash and rinse cycles when the agitator is supposed to be working. Fix or toss? Thanks My Maytag Performa makes a grinding sound when it agitates. When it starts to dump the water it ...
grinding noise when it agitates The washer fills and drains fine. It makes a loud grinding noise when it starts agitating. After a minute it stops, making the noise only intermittently. The same thing
...grinding noise, then tries to agitate (but isn't ), then loud grinding noise again. Error codes show lid switch and pressure switch errors. The washer does drain, and it also spins, but it's not ...
Question about CAWC529JQ Top Load Washer
...grinding noise (sounds like a loud timer & heard near the underneath side), then noise stops, drum starts for a second, then stops. Then pause, then sound and process repeats. I can spin drum easily ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions