Questions & Answers for: goodman furnace red light blinking

Ad

Question about GMS90703BXA Heater

3 Answers

...goodman gas furnace. the furnace is blowing with cold air. no flame. the thermostat is running on battery. the status light on goodman is blinking 4 times. seems open limit switch on the panel ...

Ad

Question about GDS80904BNA Open Flame Heater

2 Answers

...goodman gmp075-3 and it is flashing # 4 code the blower on exaust will stay on and wont shut off the light blinks 4 times it says open limit switch There is a Primary High Limit Switch towards the ...

Ad

Question about GMS90703BXA Heater

1 Answer

...Goodman furnace GMPN080-4 REV B. I had the blower motor take a dive, so I replaced it with another equivalent 115 VAC 60 Hz 1/2 HP motor. I replaced the 10.0 MFD +10% -5% capacitor with a 7.5 MFD ...

Question about GMS90703BXA Heater

1 Answer

Goodman furnace I am not sure. There is no model number or brand name. I assume its goodman because of the condensing coil. They were installed at the same time. Its a 3 ton unit. The control board ...

Red light blinks 4 times, will only cycle once The corresponding code says "open high limit". I havent timed it but the initial cycle seems like it lasts 20 minutes or more. Thanks for any help!! the ...

goodman furnace model#GCH90904CXAB the red light goodman furnace model#GCH90904CXAB the red light blinks 4 times. The air stays on continuously but there is no heat. What could be the problem? This ...

...Goodman furnace (model GMPN080-4) for the first time this fall, and... nothing. The fan works when the thermostat is set to "off" or when the temp setting is lower than the actual air temp. But once ...

Question about GMS90703BXA Heater

1 Answer

...goodman furnace will try and light three time before it faults out for safety reasons. Adjust the flame sensor so that it is closer to the flame or actually in the pilot flame. If the flame sensor is ...

Question about GMS90703BXA Heater

1 Answer

Goodman gas furnace high limit switch Goodman capf1824b6ca gas furnace. Unit runs and just blows cool air. Red indicator light blinks 4 times meaning high limit switch. I took off the covers and ...

Question about GMS90703BXA Heater

1 Answer

Red service light blinks 4 times. The limit switch is a credit card size shaped switch right behind the burners which has two wires attached to it. This switch will trip if the Furnace is overheating,

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Heating & Cooling Experts

Paul Carew

Level 3 Expert

3500 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

john h

Level 3 Expert

22533 Answers

Are you a Heating & Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...