Questions & Answers for: Chevrolet Venture gm harness

GM says it isn't their problem, talk to the dealership.. The lights flicker when you put it into park or neutral. I have to push the battery all the way to the left and back to get it to start. And no

...GM dealer can't figure it out. I had relay replaced and sensor hard to reach so they don't go there. Thanks John You could replace the sensor or try disconnecting the DRL control module .What relay ...

...harness from the wheel bearing sensor. Remove wires and spray clean with a good solvent electric spray, and check the condition of the receptacle. I have had these problems with my 02 AWD so many ...

...on these vans. Take the tailight assembly out and inspect the harness and connectors for the slightest sign of melted plastic, I'm betting you'll find a problem. GM sells a repair harness for

...GM will be re-flashing cars outside warranty for free. They will want their $100 for it. Some hands on people I found had purchased a new EGR valve and changed it but the problem ...

...GM dealer. I repaired this body connector on several Venture vans. All the terminals in the plug end should be inspected for a tight fit. Any burnt connections need to be replaced. A used connector ...

...harness and then you can splice in your radio into the new connectors ends that are labeled for what they go to. where you bought the new radio.. they should have asked if you need a Auto adapter. So ...

...Gm here is a service bulletin on this subject ( The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI. Condition/Concern: Some customers may comment on ...

...harness wires, output wire, battery cables, ground points and make sure the installation is correct and tight. Believe it or not some alternators of gm vehicles have a printed circuit in them for ...