...I bought a new knob , how to replace it? Hi, Do you mean the steam knob? if so you have to take a screw driver between the chassis and the knob, then you do a ****. There are some kind of glue on
knob part in the door use lock tight on screws. The screws in the frame/jam you have to drill out and glue in a dowel pin Then you can rescrew the screws in after the glue drys for at least 30 mintues
...directions and mix the glue put it on both the knob and the part the knob goes on wait untill the glue gets tacky then put the knob back on wait 24 hrs. before you use the iron so that the glue can ...
...do I get it back? the knob hasworn of the teeth of the control knonb get some super glue glue the knob back on wait a 1/2 hour and your back operating and rate me so I will give you more
Question about LTE6234D Top Load Stacked Washer/Dryer
...the knob itself just broke. You would do better to replace the knob than glue it because if you glued it and ever had to replace the timer then you might cause more damage getting the knob back
....................need your help immediately. if it's broken get a new knob. don't glue anything. look on the shaft of the timer and see if there is a little clip on there. if so it goes inside the ...
...knob and connect broken plastic parts with glue (liquid form). Make sure little metal inside the plastic is on front end. 3. Apply glue (gel form) around plastic then slide the metal spacer over. Add ...
...knob stem at the edge and twist the ends together. Snug it just enough to hold it in place. Have the pliers ready and apply some glue into the cracks. Using the pliers, twist the wire ends until the ...
...knob and connect broken plastic parts with glue (liquid form). Make sure little metal inside the plastic is on front end. 3. Apply glue (gel form) around plastic then slide the metal spacer over. Add ...
Question about LRG30855ST Stainless Steel Gas Range
...glue kit wrap the out side of the knob with a couple of turns of the tape cut and adhere the wrapped knob with the tape. Turn on the solvent glue tool and coat the inside of the bottom of the knob ...
Usually answered in minutes!
1,392 Questions
801 Questions
725 Questions
572 Questions
453 Questions