74 cadillac eldarado blower motor resistor location it's located within the a/c PROGAMMER ( part of the circuit board ) . The programmer is located behind glove box. Glove box must be removed,
...glove BOX, A/C programmer. Then from under the hood, disconnecting heater hoses, and removing heater case mounting bolts.Then finally jockying the heater box from under the dash without spilling ...
glove box module. 3) Remove the programmer shield, if equipped and disconect the air mix valve link. 4) Detach the programmer vacuum and electrical connectors. 5) Remove the heater core cover, leaving
glove box. Remove the Programmer from the heater box. The heater box has studs going through the firewall attached with speed nuts on the UNDERHOOD side of the firewall . The nuts on the lower part of
...also check the wiring at the connector for damaged wiring. if all is good. remove the glove box and give me the service # off the pcm. located behind the glove box.email me at ...
glove box (6 screws). remove the little panel on the back of the back of the glove box and disconnect the air bag connectors. Disconnect the connectors for the trunk, gas tank and the glove box light.
...glove box and you can open it form the inside. Most likely the locking mechanism tab is bent. You can straighten it with pliers and test it it unlocks with a key before installing glovebox in
Question about 1984 Eldorado
glove box. Remove the Programmer from the heater box. The heater box has studs going through the firewall attached with speed nuts on the UNDERHOOD side of the firewall . The nuts on the lower part of
glove box. Remove the Programmer from the heater box. The heater box has studs going through the firewall attached with speed nuts on the UNDERHOOD side of the firewall . The nuts on the lower part of
Usually answered in minutes!
267 Questions
254 Questions
223 Questions
206 Questions
198 Questions