Questions & Answers for: Dodge gear stripped

...cable cable will not spin the old one was working untill the cable broke I put a ne one in Help Remove the drive gear from the transmission, chances are it stripped because the cable was

...case where the speedometer cable enters. You can unscrew the cable from the transmission case and the gear should be sitting right there. Pop it out and see if the gear threads are

...gear within the spedomoter that has been stripped. When you set the trip odometer (while driving?) the little gear gets stressed. This is a design flaw. I went to a junk yard to try and replace mine ...

...seat out, remove the drive shaft and try to knock the track free with a hammer. it sound like the gears are stripped. does the seat go up and down still. Because if it goes up and down then the ...

...to initiate the up and down motion, this will indicate that the gears are stripped. the gear plat will need ot be replaced in this case. If the gear assembly is ok, go ahead and replace the

...D-150 w/ and automatic transmission and when I shift the needle doesn't line up with the correct gear. I've tried adjusting the needle but it still won't line up. mine is the same way but its on ...

...start to work but stop at top of stroke. Then makes a weird grinding noise. You can move blades by hand . Think the motor stripped a gear sounds like you are right the only gears are in the ...

...stripped teeth on it. It should have a domed cover held on by 4 bolts near the back by the tail housing. take the cover off and pull it out and see if it is worn where it rides on the output shaft. ...

...stripped wiper arm connections/post and/or wiper motor gear...or possibly bent operating assembly,,,first remove the arms from the post.they should have a small locking device just under the arm at ...

be considered the throttle body on a gas engine) has stripped the gears. The early build 6.7 had poor plastics in the gear housing that led to a high failure rate of this component with stripped gears