2003 saab 9-5 replaced head gasket because of overheat sent out head to be resurfaced put it all back with new head bolts and gasket now has p300 misfire on idle only 1500 rpm and up no miss can be ...
...heard that the turbo can leak coolant. will this cause water in the oil. or is this simply a head gasket? thanks Ian as the turbo is cooled by water and if the bearings fail yes its possable if the ...
I had white smoke from the tail pipeand getting hot ... I had the heads done , gasket valve . and resurfising. when I got the saab back ,I drove it about 49 miles started driving slugish , bufs of ...
...now anything i can do to get rid of smoke and smell get it inspected, you may have a blown head gasket. If you do not get it looked at and it is a head gasket issue you could destroy the 02
...housing. Remove the housing (not the hose) from the engine (2 bolts), remove the old thermostat and gasket (scrape the old gasket off if necessary), insert the new gasket and thermostat, and replace ...
...transmission fluid CHECK UNDER VECHICLE IF TRANSMISSION FLUID UNDER TRANSMISSION MORE LIKELY PAN GASKET LEAKING FLUID.IF FLUID HAS NOT BEEN CHANGED THE PAN GASKET GET HARD LEAKS FLUID.THATS IF YOU ...
...coolant system and find where is leaking. You can purchase it at Harborfreight tools. Could be head gasket, Throtllebody gasket, intake gasket and others... Good luck. The most common problem with ...
can a blown head gasket cause a car to over heat Yes, if you are uncertain of a blown head gasket. Just check the oil dip stick for traces of water mixed with the oil. Come on now Of coarse it will ...
Question about 2004 9-3
...overheat, has just started to happen.... no obvious leaks The classic cause of this is a head gasket leak to the coolant jacket, which will cause quick overheating. You may see white bubbles in ...
Question about 2007 9-3 Aero Convertible
oil pressure sensor replaced 9/14/2015started to leak oil again. Valve cover gasket replaced 1/6/2016 9/14/2015 now leaking oil again When you replace the rocker cover gaskets, clean the surfaces ...
Usually answered in minutes!
557 Questions
442 Questions
322 Questions
335 Questions
176 Questions