Questions & Answers for: Whirlpool gas but no spark

gas control is a switch that will turn on the spark module when rotated to the light position. One or more of these switches has failed. Some models these switches are individually replaceable, others

...is the problem will have be a new module This happened to me, same model it was the gas valve and the spark module that needed replacing, when the gas valve went it eventually caused the spark to

...spark ignition and gas distribution for Whirlpool self-cleaning gas freestanding ranges. You must familiarize yourself with this system before attempting any repair. Look through this service repair ...

gas cooktop and spark ignitor started sparking on its own I used very soapy sponge and cleaned cooktop. About 45 minutes later the spark ignitor started clicking all on its own. When I turn on the gas

...gas top range ignition sticks (will not stop sparking unless power cord is unpligged)....tried hair dryer on all burners near spark, but problem still exists......is there any other DIY solution ...

...spark keeps on clicking... Gas Range Repair Burners Keep on Clicking heatman101 Most likely one of spark switches got stuck in close position. Those switches come harness on kitchenaid and whirlpool ...

GAS OVENS The spark igniter tip is dirty (can clean it with either a little wire brush or a piece of fine sandpaper). 2) The Pilot flame is too low, and the tip of the igniter is not in the flame good

...GAS OVENS 1)The spark igniter tip is dirty (can clean it with either a little wire brush or a piece of fine sandpaper). 2) The Pilot flame is too low, and the tip of the igniter is not in the flame ...

glows to heat a thermocouple which opens the gas valve. There is no "spark" involved. Depending upon how faint the glow is, the thermocouple may not be heating sufficiently and may have to be replaced

...gas valve cause the spark electrode to not spark ?. I have removed & cleaned the spark electrode a couple of times. 3 Can I check the relays on the main board to see if one is faulty without removing ...