...on. more than likely the gas solenoid is loose and vibrating when powered up to open gas valve, you can try to tighten its mounting,but if its the solenoid itself internally loose its new solenoid ...
...The hot surface igniter can be tested with a ohm meter or you can take it to an appliance parts store and sometimes they will test them for free. Sounds like it could be a bad gas solenoid
...gas flow solenoid valve, bench test or have it tested and or replace. Follow the gas line to machine .This should be your gas solenoid If solenoid works fine, there must be a wire broken going it to ...
...gas solenoid valve gets a "gas It appears that the gas solenoid valve gets a "gas lock" in it as it does not energise every time. If I loosen the gas pipe fitting between the knob and the ...
Question about 40 Gallon FVR NATGAS Water Heater 6 YR 22V40F1
...gas control, and solenoid clicks off.You can hear it click, and this is how you test it.However, since you are getting gas to pilot light, then the solenoid is not the problem.This leaves 4 possible ...
Question about 2007 Suburban Three-Quarter-Ton LS
...gas cap if sucks air vent solenoid or gas cap. take gas line loose at motor cycle key to pump gas in glass jar. check for water Gas nozzle shuts off check engine light Ricks Free Auto Repair ...
...solenoid switches that control the gas flow. They go bad frequently, (and even more frequently when you buy cheap Chinese replacements). Replacing them is _very_ easy, and there is no danger of ...
Question about 2007 Suburban Three-Quarter-Ton LS
...solenoid switches that control the gas flow. They go bad frequently, (and even more frequently when you buy cheap Chinese replacements). Replacing them is _very_ easy, and there is no danger of ...
Question about 2007 Suburban Three-Quarter-Ton LS
...solenoid switches that control the gas flow. They go bad frequently, (and even more frequently when you buy cheap Chinese replacements). Replacing them is _very_ easy, and there is no danger of ...
Question about 2007 Suburban Three-Quarter-Ton LS
...gas solenoid on my millermatic 211. however no gas to the tip. tank 3/4 full. have gas to flare fitting that attaches to unit. do you think bad solenoid? Guessing you measured the power at the ...
Usually answered in minutes!
1,163 Questions
465 Questions
395 Questions
390 Questions
353 Questions