Questions & Answers for: gas range ohms

GAS RANGE MODEL # MGR5750 ADW The supject range did not work anymore after the cleaning cycle. An error code F1 is showing in the display. Could you please tell me what the problem might be. Thank you

ohms. As it heats the resistance goes up, and thus the amperage draw goes up, which is the critical component to release of gas and thus ignition. The ignitor needs to reach 3.2 to 3.6 amps before the

sounds to me more like the ignitor itself. It has to draw so many amps to open up the gas valve. Check the sensor first. If it ohms out, change the ignitor. I think your problem will go away. Tenbears

gas range purchased Feb. 2000. I had a new igniter replaced in July 2008. Now the oven temp will not heat higher than 350 deg and must press down arrow to start, plus the broiler works only on low and

...gas range that the broiler and oven The Broiler and oven will not turn on. I checked the resistance on the solenoid for the gas valve which were supposed to read 216 ohms but the broiler read 204 and ...

...gas range F3Open oven temperature sensor circuit Measure oven temperature sensor circuit at oven temperature sensor (should be approx 1100 ohms at room temp); check for cut or pinched wire or loss of ...

...gas range repeated F1 and F3 error messages. Oven shuts down. HI, You will need to check the oven sensor wires that link the actual sensor to the main control board. Make sure that the contacts are ...

hotpoint rgb745bea2ct oven doesnt keep temp. can i ohm it out sensor? At room temperature the temp sensor should be 1100 ohms plus or minus 50.

...gas range says F-3. Is this My Kenmore gas range says F-3. Is this repairable? HI, You will need to check the oven sensor wires that link the actual sensor to the main control board. Make sure that ...

gas range orven takes hours before it lights? Oven takes a long time to preheat: Igniter? - Hartford Courant How to Replace a Kenmore Gas Oven Igniter - Kenmore Gas Oven Takes a Long Time to Preheat -