gas pedal @ all. i found out it was what is called an "idle control valve" i went to autozone, bought it & replaced it & TA-DA!!! back to normal she went. i'd check into that to see if it could be the
...oil change light I changed my oil The procedure is in your owners manual. On some GM's you turn on the key (do not start engine) and press the gas pedal to the floorboard 3 times within 5
working first thing to check is loss of gas pressure due to leaks , this is the most common failure. if gas is good then could be a number if things , compressor , climate controller unit , bad wiring
...gas pedal, turn ign to run and within 5 seconds fully push and release pedal 3 times then wait with foot off of pedal for about 10 sec I tried for three weeks to get that off the cuff answer that ...
it accelerates on its own Make sure the floor mat isn't interfering with the gas pedal. I had that problem once before.
...gas pedal and slowly press it, everything goes good, but if you need a little bit of power then the aztek misses and shakes till gas pedal is released. i've the air flow sensor replaced, any other ...
gas pedal. You need to take the breather tube off of the throttle body and clean the throttle body and the throttle plate with carburator cleaner to remove the gumm that is causing it to stick.Be sure
...cut off ( radio, cluster, every lights etc. ) but engine still running and it happen while driving. Push the gas pedal and everything's back on. 150000km, broken ground wire on the ...
Question about 2004 Aztek
...GAS PEDAL. WHAT CAUSES THIS? WHEN PRESSING ON GAS PEDAL, THERE IS A VIBRATION SOUND. WHAT CAUSES THIS? you don't say where the noise is. that is important to give a clue where the issue is. when ...
How to reset change oil light on a 2003 pontiac aztek easiest way is to turn key on to just dash lights n floor gas pedal n release 3 times real fast
Usually answered in minutes!
917 Questions
342 Questions
278 Questions
263 Questions
123 Questions