...2) In the proper tightening sequence (as shown above), torque bolts initially to 22 ft.lbs. (30Nm) 3) In the proper tightening sequence, now torque bolts to 45 ft.lbs. (61Nm) 4) In the proper ...
over heat when driving on city street ,at freeway speed ok changed coolant ,thermostate, hose...same problem Did u chk to see if your fan is coming on? There is a fan sensor and then there is the fan ...
galant 2 ltr 16 valve petrol ?? as this setting up is also relating tooil pump and the balance shaft set up of marks you would be best with full instructions and a diagram i can scan and e mail to you
My car seems to be over heating. The meter goes all the way up after Ive been driving and I come to a stop, but once I start the car moving again the meter goes back down. What do you think the ...
2 years and since he did this, I don't trust it at all. It is probably related to the crank angle sensor possibly being damaged (location under lower crankshaft pulley). But more likely the timing
...Galant no start, no spark, no injector pulse plz help!!! Hello, last month drove car less than a mile and when I tried to start her back up a few hours later the car cranked but would not start. ...
2 Turn the ignition on and use your DVOM to check for voltage to the ignition module and the positive terminal of the ignition coil. Place the negative lead of your DVOM to a solid ground and use
Question about 1994 Galant
What is the timing marks on a 1989 Mitsubishi galant 2.0 .mechanic says it has 2 timing belts. Thanks desperate found this helpful answer from mitsubishi mechanic on JustAnswer com
galant 3.0 V6 it was running good no problems only a bad oil leak from the valve covers on changing the gaskets we saw the timing belt was very loose and in need of changing. after getting it the rest
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions