Questions & Answers for: Fender gain

...my amp it makes a loud beeeeeeeeeeeeeeeep sound. what can i do?. Turn the volume down. Check your gain. That should solve it. Volume way too loud i've got the same problem, volume, gain and others ...

...- "normal" and "drive." When you are on the normal channel, the "volume" knob controls your gain. In the "drive" channel, the drive knob controls your gain. In both channels, the "master"

my pre amp is loud when it's mixted is this a tube This unit has a lot of gain. It is probably normal. It is important to balance the inout gain and master gains of guitar amps. Not too high a setting

No Reverb operation? New reverb unit. Output to amp has lots of gain. Has no input signal to reverb. I don't have a schematic for this unit. Do you have any ideas??? Ed Sch: ...

single coil feeds back in the the 3 position Replace with a potted/waxed pickup. Play with less gain or not so loud orstand further from or beside the amp. In 3 position, I assume you mean all the way

hello, i have a Boss FDR-1 and the first potentiometer (level-gain) is broken, i would like to find and order one. can you do that? thanks Your best to order this item from Fender parts dealer. Here ...

...side. Warning: very dangerous voltage there!! Make sure the guitar CANNOT hear this amp. At high gains with distortion, feedback is possible with the sound rattling the strings. You can try

...preamp tubes going bad? Thanks, Aaron The tube at V2 position, the "B" section provides additional gain for the drive channel over the clean. It would be uncommon for this tube to go bad in this way ...

...inside your computer before. Electrically this is no problem, nothing will be damaged. Turn the gain and volume knobs down and apply a signal from your Mac. Gently increase gain and volume. Et ...

...isn't much of a problem. But when I have the distortion channel on, especially with the More Gain switched on, there is such a terrible humming/buzzing/white noise that basically ruins any ...