the transmission will not shift into 1st, 2nd or overdrive. It is an automatic. The diagnostic said g1 gear ratio. What is the problem? "gear ratio" problem is actually misleading. The transmission is
What are the check engine light codes. Their is a fault with the electronics on one of the vehilces electrical circuits. This will bring up the malfunction indicator light, you will need to see a ...
Engine Light on Their is a fault with the electronics on one of the vehicles electrical circuits, or one of the sensors is activated and reading a mechanical fault. This will bring up the malfunction ...
check engine code 55 jeep grand cherokee laredo v6 1997. transmission wont shift properly also pulling code 21 and i figured out that one is for the throtle position sensor These are the fault codes ...
fault code 765 Fault code "765"? This is NOT a legitimate fault code for a 2004 Jeep Liberty. You should probably try scanning again using the proper equipment.
...offroad or on slick pavement). The acceleration switch contains three separate mercury switches (G1, G2 & G3), each oriented in a different direction to monitor the vehicle's motions. The ...
ehgine check light on and restricted performance message run fault codes and repair/replace fault found. If you can get the vehicle to an Autozone, Checker, or O'Rieleys, have them do a code pull, ...
removing the front break line double posted. back up one post. or buy the right tools seen here at Sears (random ...
fault codes p0700 P0700 is a generic transmission fault code. It only means that you have to take it to a shop, so that they can read the fault code with a scanner in the transmission controller.
that it? Q1: does it crank? there just one question,, no more fault logic trees by me../ we have up to 20 tests and tools to not guess.. so...... G1: now my wild and useless guess, the battery is dead
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions