Questions & Answers for: fuser thermistor open hot roller

Question about CLP-510 Laser Printer

2 Answers

...fuser? there is a 2 wire device (thermistor) that rests against the fuser roller to measure the temperauture. if the fuser is getting quite hot, suspect the thermistor to be either dirty (remove and ...

Ad

Question about SCX-4216F All-In-One Laser Printer

1 Answer

...thermistor) and a thermal fuse/cutout. You could measuring fuser removed from machine, checking lamp etc for open circuit, thermistor should be neither short or open circuit. These days we dont, we ...

Ad

Question about T430 Laser Printer

1 Answer

...either disassembling the fuser and replacing the thermistor ( if you can find one) or replacing the fuser assembly. so i would suggest that take it to nearest service centre of lexmark. best of ...

Question about Aficio 2022 Black and White Copier

2 Answers

...thermistor in the fuser that may have toner buildup on it. If you can remove the fuser, check the thermistors that are riding on the heated roller and using a plastic tool (make sure it's cooled off) ...

Question about Infoprint 1572 Laser Printer

1 Answer

...thermistor check failure. Fuser page count between 0 and 99,999. ? Noisy thermistor signal. ? Intermittent connection. ? Thermistor cable not connected or thermistor actually open. Go to ?924.xx?Hot ...

Question about Infoprint 1572 Laser Printer

1 Answer

THERMISTOR CAUSED FUSER TO OVERHEAT AND POPPED THERMOSTAT.THERMOSTAT IS PROBABLY STILL GOOD THERMISTOR AND HOT ROLLER MAY NEED TO BE REPLACED. TURNING ONAND OFF OR UNPLUGGING WILLNOT RESET THIS SAFETY

Thermistor? What about the Fuser Roller? The Thermistors start to work bad because of the toner crust in the Fuser Roller. I advise you to change not only the Fuser Roller but also the Pressure Roller

Question about DP-C322 Copier

1 Answer

...of the machine. Could be a bad fuser motor, loose connector, an open fuse or dirty thermistor. Does the machine have a bad paper jam right now? That will cause the motor not to turn. Hope this ...

Question about DP-C322 Copier

1 Answer

thermistor, drum. What can be a problem ! R u using original toner? if no, replace ori. if yes, r the hot roller in the fuser hot enough? is there any gap between hot roller and pressure roller? toner

Question about KX-FL611 Plain Paper Laser Fax

2 Answers

...thermistor inside the fuser and detected with the voltage input into IC 300-D19 When CS3 occurs remove drum unit & fuser unit out safely after disconnecting 3 connectors underside.Dismantle it, ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

k24674

Level 3 Expert

8093 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66963 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...