Questions & Answers for: Xerox fuser hot

...to replace the fuser module. The part number is 008R12904. You can look in the fuser and see if there is something stuck under the front thermistor. But be careful that fuser is extremely HOT.

...fuser is the section that rolls the copy between a pair of hot rollers to bake the powdered toner into the page, making it permanent. Copiers and laser printers all have sensors and heat-regulating ...

fuser is hot but i think its supposed to be. Almost every sheet gets jammed. Yes it is supposed to be hot. Let is sit off for an hour. Open the right side as if you were removing a jam. You will see 4

...will go away, but it was the paper jam inside the fuser that caused the fault code. The fuser simply got too hot with the paper in there and burned up, apparently. Checking the doors on

...fuser. If its not hot enough or just plain dead, it will give out an alarm similar to what your getting. You probably need to replace the fuser unit. You have a lower fuser and an upper fuser. You ...

...error FUSER TEMP could you please help me to solve? It indicates that the fuser is either not hot enough or too hot. In most cases this is caused by a failed fuser that will require

...fuser error" occurs when the printer detects that the heating-element is NOT generating the correct temperature, i.e., not hot enough to properly melt the ink. Take the printer to a qualified ...

...380 on 7345. If the toner rubs off the page after it comes out of the printer the fuser is bad. Fuser wires get very hot, so if the page isn't slightly warm, thats a good indicator of a worn fuser ...

...fuser is not getting hot enough to fuse the toner to the paper. If you can get to it then make sure all the cable leading to the fuser are hooked up well. If they are and nothing has wiggled loose ...

hot roller. If all looks all right, reinstall fuser and power up the printer. If the error returns. Your fuser most likely need replaced. I hope it's just that. Replacing the Main Control Unit Printed